MinnKota

• You are driving a car fully accelerated. To slow down, you lift your foot off the pedal to decelerate allowing only the proper amount of gas (power) to be used. This burns less gas than the first analogy and does not heat up the brake system.
• Same theory applies to the Maximizer. Only the necessary power to go the desired speed is delivered to the motor providing extreme efficiency and longer running time.

• Extended trolling time (up to 5x longer on a single charge).
• The Digital Maximizer speed control saves valuable power over a conventional speed coil motor.
• The Digital Maximizer allows more fishing time on your battery charge, up to five times longer run time per battery charge, compared to the 5-speed switch.
• With variable speed control, the Digital Maximizer allows for proper speeds to be set and maintained while trolling lures for proper presentation.
• Virtual speed adjustments for changing conditions.
• The Digital Maxmizer allows for fine-tune speed adjustments.
• The Digital Maximizer allows the user to control boat speed more effectively in changing environments.

• Since speed coils reduce the power going to the motor, the Digital Maximizer feature was designed to eliminate this inefficient speed control method by using rapid on/off switching. The Digital Maximizer is simply a switch that turns the connection to the battery on and off 20,000 times per second.
• If “on” time is longer compared to “off,” the motor receives more power. If “off” time is longer, the motor gets less power. Since there is minimal power lost to accomplish this, the overall motor is very efficient.

Choosing the correct shaft length is important so that the angler’s electric motor does not cavitate, creating fish-spooking noise. The rule of thumb is that the center of the motor section should be submerged 9". In general, shaft length selection is more critical with bow-mount motors versus transom-mount motors. Most boat transoms are similar in their distance to the water, and Minn Kota’s standard transom shaft lengths should be adequate. With bow-mounted motors, there is much greater variation in shaft length requirements. Measure down from the mounting surface of the transom or bow to the water level. Add 5" to waterline measurement for fishing in rough water. Add 12" to waterline measurement for steering a hand control motor while standing. Use this measurement and the tables below to find the appropriate shaft length.

Transom Guide

Transom to Waterline	Recommended Shaft Length
0"-10"	30"
10"-16"	36"
16"-20"	42"
Over 22"	Consult Factory

Bow Guide

Bow to Waterline	Recommended Shaft Length
0"-10"	36"
16"-22"	42"
22"-28"	48"-52"
28"-34"	54"-62"

Engine Mount Guide

• Minimum clearance required from spine of outoard to end of cavitation plate (see diagram at right).
• Cavitation plate to waterline 13" (minimum).